Zip Econoboil Instant Hot Water Dispenser
- 3 & 5 Litre Capacity
- Long life heating element
- Two way Catering tap
- WRAS Approved
Zip Econoboil
3 & 5 litre instant boiling water dispenser, is a wall mounted dispenser which is white enamelled durable steel with a corrosion resistant white powder finish.
Zips patented high precision temperature control systems are designed to keep the boiling water within one degree of boiling point. This means boiling water, and only boiling water is delivered.
Water Boiler
EconoBoil, wall mounted instant boiling water appliance employing patented twin chamber boiling water steam-heat-boost™ technology to recycle energy from steam to pre-heat the incoming cold water and thermostatic temperature control, incorporating a copper boiling water chamber and equipped with an external two-way classic tap.
- Saves time, saves energy and saves you money.
- Capacity : 3 & 5 Litres
- Energy Rating : 1.5kW
- Delivery rate : Up to 30 cups at a time.
- Recovery rate : Up to 140 cups/hour
- Boiling chamber : Twin chamber in copper with steam, heat, boost technology
- Tap : Two way, chrome-plated classic catering style tap
- Approvals : WRAS approved and CE Endorsed
- Warranty : 1 year on site manufacturer's warranty
| Product Code | SKU | Colour | Height (mm) | Width (mm) | Depth (mm) |
Delivery Rate |
Capacity |
| HS503 | 303542 / 403542 | White | 431 | 289 | 160 | 18 cups/hr | 3 Litres |
| HS505 | 305542 / 405542 | White | 465 | 318 | 198 | 30 cups/hr | 5 Litres |
Technical Specifications
Installation : Should be installed over a draining board or worktop fitted with a drip tray - tap spout should be no higher than necessary to fill large pots. Leave a minimum clearance of 150mm above, 65mm left and 20mm right. Hanging and fixing screws supplied with wall plugs.
Plumbing : Designed for direct connection to a to a cold water supply with a minimum pressure of 1 bar and a maximum pressure of 7 bar. A pressure reducing valve must be installed if water pressure is likely to exceed 7 bar. An isolating valve should be installed between the water supply and the heater.
Concealed plumbing : Connect inlet and vent pipes from the rear via 15mm capillary elbows.
Exposed plumbing : Connect inlet and vent pipes from the bottom directly to 15mm compression fittings with nuts and olives provided.
Venting : The vent must discharge to a safe visible position as, under certain conditions, the vent may discharge cold or boiling water and/or steam. The vent pipe outlet must be connected via a tundish to a 15mm copper vent pipe which has a continuous fall, to a safe and visible place. The bug screen supplied must be fitted to the end of the vent tube.
Electrical : To be wired to a double pole switched fused spur with a minimum break capacity of 13 amps. Installation must comply with current IEE regulations.
Caution : In some hard water areas where mineral scale accumulation may be an issue, consideration should be given to the maintenance required. A suitable form of scale management may be necessary.
